DW series conveyor-type drier

◇ Product outline
     This machine suits to the drugs manufacture profession "GMP" the management, carries on to the drugs and the appliance antiseptic and is dry. This factory through accumulates for 30 years to make each kind of drying oven the experience and unifies the domestic and foreign experiences and the home "GMP" the request, the careful design, the manufacture, provides the reliable GM100 series product. Enjoys the high reputation in the medicine profession.

◇ Principle of work
     The material by the feeder even makeshift bed on the ground on the net belt, the net belt generally uses 12-60 item stainless steel silkscreens, drives by the transmission device in the dryer moves. The dryer is composed by certain units, each unit hot blast independent circulation, the partial exhaust by specially arrange the wet air blower to discharge, the waste gas by the regulating valve control, the steam upward or downward passed through the shop full material by under by on the net belt to complete thermal and the mass transfer advancement, carries off the material moisture. The net belt slow migration, the running rate may act according to the material temperature free adjustment, the dry after end product continuously falls receives in the material. About circulates the unit to need according to the user to be possible nimbly to provide, the unit quantity also may according to need to select.
◇ Product use
     The dehydrated vegetables, the diet pellet, the monosodium glutamate, the organic pigment, the synthetic rubber, the third thintextile fiber, the drugs, the raw material for medicine, the smallwoodware, the electronic non- component get older, the solidification and so on


◇ Technical parameter

Model	DW-1.2-8	DW-1.2-10	DW-1.6-8	DW-1.6-10	DW-2-8	DW-2-10
Single number	4	5	4	5	4	5
Band width m	1.2	1.2	1.6	1.6	2	2
Dry section chief m	8	10	8	10	8	10
Shop material thick mm	10-80
Application temperature ℃	60-130
Steam pressure Mpa	0.2-0.8
Steam consumption Kg/h	120-130	150-375	150-375	170-470	180-500	225-600
Drying time h	0.2-1.2	0.25-1.5	0.2-1.2	0.25-1.5	0.2-1.2	0.2-1.5
Dry intensity Kg H2O/h	60-160	80-220	75-220	95-250	100-260	120-300
In machine total output Kw	9.9	12.1	9.9	12.1	18.2	22.2
Equipment total output KW	11.4	13.6	11.4	13.6	19.7	23.

DWP series conveyor-type drier

◇ Principle of work
     DWP is the jet stream belt type dry type, the hot blast flows either the hole beam flux from the slit or about simultaneously spurts tounder to the conveyor belt on the material, because the jet stream reaches as high as above 15m/s, therefore heat transfer conductance heat transfer membrane extremely thin, the heat transfer coefficient big, the drying velocity is quick. When this equipment used in the air tight 气类 material above, the above jet stream still returned, under below spouted the air current still returned, again participated in the circulation. To the permeable material was mad 流束 has strong 穿透性 and in the material interior diffusibility. The use heat source may be the steam, the electricity, the hot-blast stove and the fuel oil smoke ventilates and so on.
◇ Product use
     The DWP jet stream conveyor-type drier mainly uses in the textile fiber, the plaster tablet, the paper shook, the paper pulp mold, spreads the cloth to be dry and so on, also is suitable to the flap anticipates some special branches dryness.
  
◇ Technical parameter

Model	DW-1.2-8	DW-1.2-10	DW-1.6-8	DW-1.6-10	DW-2-8	DW-2-10
Single number	4	5	4	5	4	5
Dry section chief m	8	10	8	10	8	10
Shop material thick mm	10-80
Application temperature ℃	60-130
Steam pressure Mpa	0.2-0.8
Steam consumption Kg/h	120-300	150-375	150-380	170-470	180-500	230-600
Dry intensity Kg H2O/h	80-170	90-220	80-220	90-250	180-230	120-300